![]() Next, move over to TVHeadend and navigate to Configuration > CAs and add a new client with the following parameters Ĭlient name: Whatever you like (OSCam will do)Ĭamd.socket filename / IP Address (TCP mode): IP Address of the server running OSCam (if it's the same box as the one running TVHeadend, use 127.0.0.1) Next you need to add the tvheadend user referenced above, so copy the below into your er file (Files > er) I use the DVBAPI protocol to link OSCam and TVH - to configure this, copy the below into your nf file (Files > nf) ![]() In short, there's two parts, setting up OSCam and then setting up TVHeadend If OSCam is connecting to your card OK and the only problem is getting TVHeadend to get the codeword from OSCam then check out my thread and take the relevant parts to configure TVH to talk to OSCam. P.D.: FTA channels works fine in another PC with VLC (NOTE: The PC is in the same lan 192.168.2.x) I need help for the config, it's imposible to link TVH with OSCam, but OSCam reads the cards. In a second attempt I tried to modify the config with the setup files explained in the second post of this thread: OSCam reads the remote card via CCCam, but it's imposible to link TVHeadend to a OSCam server. The card for capture is an Hauppauge WinTV-HVR 4000 in a Debian 8 machine.ġ: I tried to install and configure OSCam as in the 2nd post of this thread:Ģ. I have a problem with my config for descrambling with OSCam (CCCam) + TVHeadEnd.
0 Comments
Leave a Reply. |